Westell Technologies 2110 Betriebsanweisung PDF herunterladen (Seite 33)

030-300220 Rev. D 31 November 2002

WireSpeed Dual Connect Modem

User Guide

DHCP Start Address

Displays the starting DHCP Address. The Start Address must be within the IP

address and lower than the End Address.

Dynamic Host Configuration Protocol automatically assigns IP addresses to

devices added to your LAN (Local Area Network).

DHCP End Address

Displays the ending DHCP Address. The End Address must be within the IP

address and higher than the Start Address.

Dynamic Host Configuration Protocol automatically assigns IP addresses to

devices added to your LAN (Local Area Network).

DHCP Lease Time

Default = 01:00:00:00 (dd:hh:mm:ss)*

Displays the DHCP lease time. NOTE: This value must be greater 10 seconds.

*(dd = days, hh = hours, mm = minutes, ss = seconds)

* Seconds must be between 0 and 59. Minutes must be between 0 and 59.

Hours must be between 0 and 23.

DHCP Server Enable

Factory Default = ENABLED

Allows you to enable the DHCP server

When DISABLED, this feature will transfer this functionality to your

computer.

If you click on the save changes button in the DHCP Server Configuration screen, the following pop-up screen

will be displayed. Click on OK in the Load new Private LAN configuration? screen. This will save your DHCP

settings.

If you click Cancel in the Load new Private LAN configuration? screen, your new settings will not take effect.

If you change your modem IP Address, the following screen will appear:

Your modem will reboot automatically due to IP address modifications. After the reboot, you may need to release

and renew your IP address to communicate with the modem.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 70 71

Keine Kommentare

Westell Technologies 2110 Betriebsanweisung Seite 33